Repair Once activated but not completed — Tradetron Community
← Community

Repair Once activated but not completed

Strategy 1,227 views

yuvaraj_tradetron

Set №1
Entry(S1 E)
Repair Once(S 1 R1)
- LegTSL
- Runtime Variable : Set Repair-1
Repair Once(S 1 R2)
- LegTSL
- Runtime Variable : Set Repair-2
Exit(S1 Ex)

Consider the below scenario:
1. Entry Taken
2. Repair Once(S 1 R1) active and LegTSL is active and trailing.
3. Before LegTSL is completed in Repair Once(S 1 R1), Exit(S1 Ex) happened.

Now when we enter Entry(S1 E) again, will Repair Once(S 1 R1) be valid.If no Repair Once(S 1 R2) will be valid?

Tradetron Team Tradetron team

Repair Once fires once and isn’t checked again until there is a set exit or universal exit. After Set 1 exits and enters again, both Repair Once blocks (S1 R1 and S1 R2) are checked again for the new entry.

A Leg TSL that was trailing is tied to the earlier position and doesn’t carry over to the re-entry. Leg TSL doesn’t trail re-entries. Your runtime variables (Set Repair-1/2) persist until you reset them or a Universal Exit fires, so reset them in the exit’s runtime block if the logic depends on them. Test in Live Offline.

:sparkles: Answer written with AI from Tradetron docs (Oct 2026). Original replies are kept above. Spot something wrong? Reply below.